Categories
Пуловер с ажурным узором из «листьев»
Knitting, Knitting ideas, Sweaters, pullovers, jumpers

Пуловер с ажурным узором из «листьев»

вязаный пуловер

Пуловер нежно-розового цвета ручной работы, связанный ажурным узором из шелковистой пряжи.

Dimensions: 38/40 (42/44) 46/48

You will need: пряжа ONLINE Linia 321 Silk” (100% шелка; 150 м/50 г) — 450 (500) 550 г розовой Rose (Fb 018); спицы № 3 и 3,5.

Patterns

Pattern 1: elastic band (odd number of loops).
Front rows: кромочная, попеременно 1 изнаночная, 1 лицевая, закончить 1 изнаночной и 1 кромочной.
Purl rows: knit loops according to the pattern.

Pattern 2: purl stitch = knit rows - purl loops, purl rows - knit stitches.

Pattern 3: ажурный узор из «листьев» (число петель кратно 24 + 1) = вязать согласно схеме. На ней даны лицевые и изнаночные ряды. Начать с 1 кромочной и петель перед раппортом, раппорт постоянно повторять, закончить петлями после раппорта и 1 кромочной.

Выполнить 1 раз 1-34-й ряды, затем постоянно повторять 3-34-й ряды.

Knitting density: 23,5 п. х 32,5 р. = 10 х 10 см.

вязаный пуловер

Description of knitting

Back: 

на спицы № 3 набрать 123 (135) 147 петель крестообразным набором и для планки связать 3 см узором 1.

Продолжить работу на спицах № 3,5 следующим образом: кромочная, 0 (6) 0 п. узором 2,121 (121)145 п. узором 3, 0 (6) 0 п. узором 2, кромочная.

Через 50 см = 162 ряда от планки продолжить работу для замыкающей планки узором 1.

При ширине планки 2 см закрыть все петли по рисунку, при этом внешние по 23 (29) 35 п. образуют плечи, средние 77 п. —  горловину.

вязаный пуловер

Before: 

knit like a back.

вязаный пуловер

Sleeves: 

набрать на спицы № 3 для каждого рукава по 85 (93) 103 петли крестообразным набором и для планки связать 3 см узором 1.

Продолжить работу следующим образом: кромочная, 5 (9) 2 п. узором 2, 73 (73) 97 п. узором 3, 5 (9) 2 п. узором 2, кромочная.

Через 40 см = 130 рядов от планки закрыть все петли.

Assembly: 

sew shoulder seams.

Sew in the sleeves, sew side seams and sleeve seams.

Cross set of hinges

The set of loops is made with double thread.

To do this, you will need an additional thread at least twice as long as the length of the cast-on edge.

First, make the initial loop, for which you connect the middle of the additional thread with the thread of the ball and make the initial loop.

After this, place the single thread coming from the ball, as usual, around the index finger and pass under the fingers (= index finger thread).

Place a double additional thread from the outside inwards under the thumb and hold it under the other fingers together with the thread of the index finger (= thread of the thumb).

Now perform the 1st stitch as usual, i.e., pass the knitting needle from the outside in around the thumb, pull out the thread of the index finger and tighten the loop.

For the 2nd stitch, throw off the thumb thread and lay it from the inside out around the thumb.

Now pass the knitting needle under the thread of the thumb lying inside, pull out the thread of the index finger and tighten the loop.

This is an alternation to repeat.

After the initial row, always knit 1 purl row using purl stitches.

Related posts

Leave a Reply

Required fields are marked *

en_USEnglish