Jumper with zippers on sleeves and pockets

Longitudinal and cross elastic, original pockets and stripes along the cutouts on the sleeves - this jumper is truly rich in exquisite details.

DIMENSIONS 

36/38 (40/42) 44/46

YOU WILL NEED
Yarn (50% yak wool, 50% natural wool; 130 m/50 g) - 500 (550) 600 g color. moss; knitting needles No. 4 and 4.5; circular knitting needles No. 4 and 4.5; 10 buttons (diameter approx. 40 mm).

PATTERNS
RUBBER A
Knit (knitting needles No. 4) an odd number of loops.

Facial rows: edge, alternately 1 front crossed, 1 purl, 1 front crossed, edge.

Purl rows: knit the loops according to the pattern, while knitting the knit stitches crossed with the purl stitches crossed.

Knit the following patterns on needles No. 4.5!

FACIAL SMOOTH
Front rows - front loops, purl rows - purl loops.

RURAL STAIN STITCH
Front rows - purl loops, purl rows - front loops.

SEMI PATENT PATTERN
Odd number of loops.

1st row: * Purl 1, slip 1 stitch with 1 yarn over as purl, from * Repeat constantly, finish with 1 purl.

2nd row: * Knit 1, slip a double crochet stitch together, purl from * repeat constantly, finish with knit 1.

Repeat rows 1 and 2 constantly.

CROSS RUBBER
Alternately 2 rows of stockinette stitch and 2 rows of purl stitch.

shawl stitch
Front and back rows - front loops.

RUBBER B
The number of loops is a multiple of 4 + 2 + 2 edge loops.

Front rows: edge, alternately 2 front, 2 purl, 2 front, edge.

Purl rows: knit loops according to the pattern.

RUBBER C
The number of loops is a multiple of 4.

Front rows: * purl 1, knit 2, purl 1, from * repeat constantly.

Purl rows: knit loops according to the pattern.

KNITTING DENSITY
17.5 p. x 27 r. = 10 x 10 cm, knitted in stockinette stitch (knitting needles No. 4.5);
15 p. = width 8 cm, knitted with a semi-patent pattern;
16.5 p. x 33 r. = 10 x 10 cm, tied with a cross elastic band;
18 p. x 30 r. = 10 x 10 cm, knitted with stockinette stitch (knitting needles No. 4);
garter stitch placket – 4 p. + edge = width 2 cm;
18 p. x 27 r. = 10 x 10 cm, tied with elastic band C.

ATTENTION!
Due to the increase in the number of loops, knit on circular knitting needles in rows in forward and reverse directions.

The transverse elastic band is pulled together in height so that a curve is formed both along the bottom line and along the neck line. These curves have the same height on the pattern.

All buttons are decorative and are sewn through both layers of the placket; no button holes are required.

COMPLETING OF THE WORK
BACK
Cast on 97 (103) 109 stitches on knitting needles and knit 2 cm for the placket with elastic band A.

Continue working as follows: edge stitch, 21 (23) 25 stitches in stockinette stitch, 15 stitches in stockinette stitch, 23 (25) 27 stitches in cross rib stitch, 15 stitches in stockinette stitch, 21 (23) 25 stitches in stockinette stitch, edge stitch .

Attention!
All data below in centimeters refers only to the front surface.

For whole knitted sleeves, after 36.5 cm = 98 rows from the placket, add or cast on 1 x 1 p. on both sides, then in every 2nd row 5 x 1 p. and 1 x 33 p. and knit with stockinette stitch = 175 ( 181) 187 p.

For the shoulder and sleeve placket, after 53.5 cm = 144 rows (55.5 cm = 150 rows) 57.5 cm = 156 rows from the bottom bar, continue working on all loops with elastic band B, while in the 1st row in the middle add 1 p. (subtract 1 p.) add 1 p. = 176 (180) 188 p. This increase or decrease, respectively, serves to balance the pattern and is not taken into account in the pattern.

After 3 cm from the start of knitting the straps, close 66 (68) 72 sts on both sides and for the collar, knit another 5 cm on the middle 44 sts with elastic B, the first and last loop = edge loop. Then close the loops according to the drawing.

BEFORE
Knit like a back.

POCKETS
On the initial row of the front strip, mark the outer 6 loops (including the edge ones). Before turning the bottom edge up.

On circular knitting needles No. 4, on both sides of the mark from the next 30 (32) 34 loops of the initial row of the front bar, 1 loop each and knit in stockinette stitch, starting with 1 purl row.

After 17.5 cm = 52 rows from the set of loops, knit 1 purl row, then bind off all the loops like knit stitches; pocket height = 18 cm.

Turn the pockets 10 cm towards the right side of the front so that the bottom of the pocket (= fold edge) is located 4 cm below the bottom edge of the front, the reverse side of the pockets is located on the outside.

Sew the pockets together with the folded edges on both sides to the front by 10 cm.

Then turn the pockets inside out and sew side seams 4 cm long.

LEFT SLEEVE PLANK
Cast on 54 (58) 62 stitches on knitting needles and knit 1 purl row; this series is not taken into account in subsequent calculations.

Continue working as follows: edge stitch + 4 sts in garter stitch (= placket), 44 (48) 52 sts in rib C, 4 sts in garter stitch + edge stitch (= placket).

After 23.5 cm = 64 rows from the starting row, bind off all stitches as if they were knit stitches.

Fold the sleeve placket so that the placket of the right side with garter stitch is located on the placket of the left side with garter stitch. Sew the ends of the strips at the closed edge (= top edge).

Then sew the longitudinal edge of the bottom strap from the inside to the sleeve.

Sew 3 buttons, evenly distributed, to the outer placket using garter stitch, capturing both parts of the placket (left and right). For clarity, mark the middle of the elastic on the closed edge C = the middle of the sleeve placket.

RIGHT SLEEVE PLANK
Knit in the same way, but fold the placket so that the placket on the left side with garter stitch is located on the placket on the right side.

ASSEMBLY
Place the front panels of the sleeves and shoulders over the back ones and sew the outer ends on both sides. On both sides, at a distance of 1 x 8 cm and 1 x 17 cm from the outer edge, sew 1 button, grabbing both layers of the strap for fixation. If desired, sew the bottom back panel on the opposite side to the 2nd button.

Sew the side seams of the collar and then sew the closed edges of the shoulder straps on both sides by 2.5 cm so that the collar does not warp. Between this seam and the next button, the trims remain unconnected.

Sew side seams and sleeve seams. Sew the sleeve strips, slightly pulling, to the lower edges of the sleeves, with the strips with pattern 6 placed at the ends of the shoulder straps, respectively, the middle of the sleeve strip is located at the side seam.