Categories
Jumper “Golden moments”
Knitting, Knitting ideas, Sweaters, pullovers, jumpers

Jumper “Golden moments”

knitted jumper

Jumper with an openwork pattern, braids and bumps. Knitted raglan cut jumper made from DROPS Belle yarn. The product is knitted from top to bottom with an openwork pattern, braids and cones. Sizes XS–XXL.

DIMENSIONS:
XS – S – M – L – XL – XXL

pattern



YOU WILL NEED:
yarn DROPS BELLE from Garnstudio (50 g 120 m, 53% cotton, 33% viscose, 14% linen)
400-450-500-550-600-650g color No. 04, dandelion

DENSITY:
20p and 26p in satin stitch = 10 x 10 cm.

SPOKES:
Double needles DROPS DOUBLE POINTED NEEDLES 4.5 mm
Circular knitting needles DROPS CIRCULAR NEEDLE 4.5 mm, length 40 and 80 cm for satin stitch faces.
Double needles DROPS DOUBLE POINTED NEEDLES 3.5 mm
Circular knitting needles DROPS CIRCULAR NEEDLE 3.5 mm, length 40 and 80 cm for elastic.
Auxiliary needle DROPS CABLE NEEDLE – for braids.


DESCRIPTION OF PATTERNS:

knitted pullover


PATTERN:
See diagrams A.1 – A.6. Select the pattern for your size (applies to A.1 and A.3).

knitting pattern
knitting pattern
knitting pattern



UNIFORM INCREASES/DECREASES:
To calculate when to increase/decrease, take the total number of stitches (for example, 92 stitches), and divide them by the number of loops that need to be increased/decrease (for example, 28) = 3.2.

In this example, to increase, we make 1 yarn over after approximately every 3rd loop. In the next round, knit yarn overs with crossed loops so that there are no holes.

For decreases in this example, tie approximately every 2nd and 3rd stitches together.

RAGLAN:
Add 1 st on both sides of the marker like this: knit to the last stitch before the marker, 1 yarn over, k2, (the marker is between these loops), k1, 1 yarn over. In the next round, knit yarn overs with crossed loops so that there are no holes. Next, knit new loops according to the pattern.

SLEEVES DECREASES:
If the openwork pattern and decreases are in one circle, make decreases in the next circle. Decrease 1 st on both sides of the marker: knit to the last 3 sts before the marker, k2 together, k2 (the marker is in the middle of these 2 sts), slip 1 st as a knit, k1 and place the slipped stitch over the knitted one.

CLOSING THE HINGES:

To prevent the closed edge from being pulled together, you can use larger knitting needles. If the edges turn out to be too tight, then you need to make 1 yarn over after approximately every 4th loop (bind the yarn overs like regular loops).

knitted jumper



Brief description of the model:
The neckline and yoke are knitted in the round on circular needles from top to bottom. The yoke is divided into lower part and sleeves. The lower part is knitted in the round on circular needles from top to bottom. The sleeves are knitted in the round on stocking/short circular needles from top to bottom.

NECK:
Cast on 92-92-96-100-108-112 sts on 3.5mm circular needles using Belle yarn. 1 round knit. Then knit with an elastic band in a circle (=2k/2p) 8 cm. After the elastic, knit 1 circle with knits, in which evenly add 28-28-32-28-28-24p - see Description of patterns = 120-120-128-128- 136-136p. 1 circle purl and 1 circle knit. Switch to 4.5 mm circular needles. Place a marker after approximately 23-23-24-24-25-25 sts (= approximately the middle of the back), from which the length of the yoke will be measured!

YOKE:
Place 4 markers in the work without knitting stitches: place the first marker at the beginning of the circle (= transition between the left sleeve and the back), place the next marker through 47-47-49-49-51-51p (= transition between the back and right sleeve), place the next marker through 13-13-15-15-17-17p (= transition between the right sleeve and the front), place the next marker through 47-47-49-49-51-51p (= transition between the front and left sleeve), 13-13-15-15-17-17p left after the last marker.
Next, knit according to the pattern - choose a pattern of your size, thus: * K1, 1 yarn over, according to pattern A.1 the next 5-5-6-6-7-7p, according to pattern A.2 the next 35p, according to pattern A.3 next 5-5-6-6-7-7 sts, 1 yo, k2 (marker is in the middle of these 2 sts), 1 yo, starting with 5-5-4-4-3-3 stitches of the chart, knit according to A.4 next 11-11-13-13-15-15p, 1 yarn over, k1 *, repeat from *-* 1 more time. 8p added along raglan lines - see Description of patterns. Continue knitting according to the pattern, making increases in every second round a total of 22-26-29-31-35-39 times = 296-328-360-376-416-448p, at the same time knitting according to the pattern in this way:
REMEMBER THE DENSITY OF KNITTING!
Pattern for front and back:
At the end of patterns A.1 and A.3, knit according to pattern A.5 over the last 13 sts of A.1 and according to pattern A.6 over the first 13 sts of A.3, knit the remaining stitches in stockinette stitch until the end of 16 raglan increases. DURING the beginning of the 3rd vertical repeat of the openwork pattern on the sleeves (i.e. on the 33rd circle of the yoke), knit the openwork pattern (A.4) also on the sleeves. Those. There should always be 1-1-2-2-3-3 stitches between the openwork pattern yarn overs and the raglan increase. With a sufficient number of added loops, knit an openwork pattern across the entire width.
Sleeve Pattern:
On the sleeves, repeat pattern A.4 vertically and knit an openwork pattern across the entire width. There should always be 1-1-2-2-3-3 stitches between the lace yarn overs and the raglan increase.

Upon completion of all raglan increases, the length of the part will be approximately 17-20-22-24-27-30 cm from the marker. For size XS, continue knitting according to the pattern (without adding raglan) to a height of 20 cm from the marker. If the piece is shorter than 20-22-24-27-30 cm for sizes S, M, L, XL and XXL, continue knitting according to the pattern (without adding raglan) to the required size.
Next round:
Work the first 91-99-107-111-121-129 sts (= back), slip the next 57-65-73-77-87-95 sts of the sleeves onto the stitch holder, cast on 8-8-8-12-12-16 new stitches (= sleeve undercut), knit the next 91-99-107-111-121-129 sts (= front), slip the next 57-65-73-77-87-95 sts of the sleeves onto the stitch holder, cast on 8-8-8-12 -12-16 new loops (= sleeve undercut). Cut the thread. Finish the lower part and sleeves separately. ALL MEASUREMENTS WILL BE TAKEN FROM THIS LOCATION!



BOTTOM PART:
= 198-214-230-246-266-290p. Place 1 marker on each side of the bottom, in the middle of the new sleeve hem stitches (= 4-4-4-6-6-8 new stitches on either side of each marker). We start the circle from the side. Continue knitting the pattern in the circle as before, knitting the openwork pattern as many times as the number of loops on the sides allows (the openwork pattern should be positioned the same way as before on the yoke). The remaining loops on the sides that are not included in the openwork pattern are knitted in stockinette stitch (= 6-4-2-6-5-5 sts between the side marker and the last yarn over of the openwork pattern). Continue working in the round to a height of approximately 24-26-26-26-25-24 cm - finishing with the 1st, 2nd, 14m-18m rounds or 30m-34th rounds of pattern A.2.
Next round: * knit the first 19-23-27-31-36-42 sts, evenly increasing 6-6-6-8-9-9 sts, knit the next 61 stitches according to the pattern, knit the next 19-23-27-31 -36-42p, evenly decreasing 6-6-6-8-9-9p, repeat from *-* 1 more time = 222-238-254-278-302-326p. Knit the first 25-29-33-39-45-51 stitches. Place a marker. Now this is the beginning of a circle. Next, knit with an elastic band. There are 2 options for elastic with a 61p pattern. If you finished with the 1st, 2nd or 30th-34th round of A.2, knit rib-1, and if you finished with the 14th-18th round of pattern A.2, knit rib-2.
Elastic band-1:
* knit the first 18 sts, k2, knit the next 21 sts, knit the next 18 sts, (k2/p2) on the next 50-58-66-78-90-102 sts *, repeat from *-* 1 more once.
Elastic band -2:
* knit the first 61 stitches according to the pattern, (k2/p2) on the next 50-58-66-78-90-102 stitches *, repeat from *-* 1 more time.

Knit with an elastic band of approximately 4 cm. Bind off the loops according to the pattern - see Description of the patterns. Jumper length approximately 51-53-55-57-59-61 cm from shoulder to hem.

knitted pullover



SLEEVE:
Re-slip the postponed 57-65-73-77-87-95p sleeves onto stocking/short circular needles 4.5 mm and knit 1p each from the new 8-8-8-12-12-16p sleeve undercut = 65-73-81-89 -99-111p. Place a marker in the middle of the new stitches. Move it while working. It will later be used for sleeve reductions. Knit a pattern for different sizes in this way:
Sizes XS, S and M:
Continue knitting in an openwork pattern in the round on all stitches. Sleeve hem loops that are not included in the openwork pattern are knitted in stockinette stitch. At a sleeve height of 4 cm, start making sleeve decreases - see Description of the patterns. Decrease every 0-10-5 cm 1-3-6 times = 63-67-69p. Next knit according to the instructions below.
Sizes L, XL and XXL:
Continue knitting in an openwork pattern in the round on all stitches. Sleeve hem loops that are not included in the openwork pattern are knitted in stockinette stitch. At the same time, in the first round, decrease the loops near the marker - see Description of the patterns. Decrease every other round 2-5-9 times, then every 4-3-2 cm for a total of 7-8-9 times = 71-73-75 stitches.
All sizes:
Continue until the sleeve height is 38-40-39-37-34-32 cm from the division. 1 round with knit stitches, in which evenly decrease 23-23-25-23-25-23 sts = 40-44-44-48-48-52 sts. Switch to 3.5 mm double needles. K2/P2 in the round. At an elastic height of 4 cm, close the loops according to the pattern - see Description of the patterns. Sleeve length 42-44-43-41-38-36 cm from division. Knit the second sleeve in the same way.

Related posts

Leave a Reply

Required fields are marked *

en_USEnglish