Categories
Openwork jumper in lavender color
Knitting, Knitting ideas, Sweaters, pullovers, jumpers

Openwork jumper in lavender color

knitted pullover

A universal model that will look good under jeans with sneakers or shorts, as well as a formal skirt or office trousers.

Dimensions: 12/14

pattern

Material: ANNY BLATT “Mango” (50% cotton, 50% modal; length 110m/50g) 400 g light blue (col 156);

 knitting needles and circular needles number 4 = 3.5 mm.

Garter stitch in the round:

1 row of knit stitches, next row of p.

Zigzag pattern A: The number of loops is divided by 18 + 1 + 2 chrome. Each row begins and ends with an edge loop.

 Persons: * p k, yo, 7 p, 3 p together, k7 p, yo, repeat from 1 p

Out r: pn, * k17, p1, repeat from *

Zigzag pattern B:

 1 – 10 r: knit zigzag pattern A.

 11 r: knit, after each loop make 2 yarn overs.

 12 r: knit, lower the yarn overs from the knitting needle.

13 – 20 r: knit zigzag pattern A.

Openwork pattern:

 The number of loops is a multiple of 8 +3 + 2 chrome. Knit according to the pattern. The diagram shows only lime rows. In purl rows, knit all loops and yarn overs.

 Start with the edge loop and loops before the repeat, constantly repeat the repeat, finish with loops after the repeat and edge. Knit once from the 1st to the 30th row

knitting patterns

Facial surface: Knit r: knit p. Purl p: purl p.

Sequence of nodes:

 30 rows of openwork pattern, 2 rows of stockinette stitch, repeat from *

Knitting density:

23 p and 40 r - 10x10 cm - zigzag pattern A 23 p and 28.5-29 r - 10x10 cm - zigzag pattern B 21 r and 29.5 r - 10x10 cm - sequence of patterns

Back:

 Cast on 111 sts and knit purl 1 row of sts. This row will not be considered mentioned in the further description.

Then knit as follows: 10 rows with a zigzag pattern A, 30 rows with an openwork pattern, evenly decrease 10 sts = 101 sts, 20 rows with a zigzag B pattern, evenly add 10 sts - 111 sts, then continue with the sequence of patterns, while in the 1st row evenly decrease 10 sts – 101 sts.

Sleeve armholes:

At a height of 31 = 94 rows from the beginning, close the armholes on both sides with 4 sts, then in every 2nd row, 2 sts and 2 times 1 st = 85 sts.

Make sure each yarn over has 2 stitches knitted together and vice versa.

Neckline and Shoulders:

At a height of 50 cm - 150 rows from the beginning, close off the middle 19 stitches and finish each side/shoulder separately. From the side of the neckline, bind off 1 time 4 stitches and 1 time 3 stitches. At a height of 52 cm = 156 rows from the beginning, bind off the remaining 26 stitches of the shoulder

Before:

Before knitting like a back, but at a height of 45.5 cm = 136 rows from the beginning, close off the middle 9 sts for the neckline. Then, from the side of the neckline, close off in every 2nd row 1x4, 2x2 and 3x1 sts, then in every 4th row p .

Sleeves:

Cast on 57 sts and knit purl 1 row of sts. This row will not be considered mentioned in the further description. Then knit as follows: 10 rows with a zigzag pattern A, then continue with a sequence of patterns, while in the first row evenly decrease 4 sts = 53

Sleeve extensions:

At a height of 3 cm = 12 rows from the beginning, add 1 stitch on both sides. Then alternately in every 4th and 6th row 7x1 stitches, knit new loops according to the pattern = 69 stitches.

Sleeve roll:

At a height of 16 cm = 50 rows from the beginning, close off 4 sts on both sides. Then in every 2nd row 1x2, 14x1, 1x2, 1x3 and іх4 sts. At a height of 29 cm = 88 rows from the beginning, close off the remaining 11 sts.

knitted jumper

Assembly:

Close shoulder seams. Using circular knitting needles, cast on approximately 80 stitches along the neckline and knit 2 cm in garter stitch. then close all the loops.

 Sew in the sleeves, close the side seams and sleeve seams.

Related posts

Leave a Reply

Required fields are marked *

en_USEnglish